Page 1 of 1
How can a start a driver in windows 98?
Posted: Fri Jun 08, 2007 4:25 pm
by Evan
How can a start a driver in windows 98?
Posted: Fri Jun 08, 2007 10:09 pm
by Anonymous
I think you mean 'How do I install a driver in windows 98', if not you may want to give a little bit more information, also this is Qbasic Q&A. Heres a link that should help.
http://www.windowsreinstall.com/install ... /index.htm
How can a start a driver in windows 98?
Posted: Fri Jun 08, 2007 10:31 pm
by Evan
nope
sorry about that what i really wanted was to know how to run a driver ?
Posted: Wed Jun 13, 2007 10:58 am
by Patz QuickBASIC Creations
QBASIC can't use Windows 98 drivers, if that's what you're going at.
You don't "run" drivers. The operating system automatically uses these files to figure out what all of those little 0s and 1s that are coming from your device actually mean. So, I don't really get what you mean when you say "run" a driver.
How can a start a driver in windows 98?
Posted: Wed Jun 13, 2007 2:53 pm
by Evan
Well a driver looks like a executable file with deferent file extension. I think.
I have this computer with windows 98 on it. When i start the it in command prompt only and type the nave a a driver i want to start it gives me this 'This Program Can Not Run In MS Dos Mode'.
If you start the computer in Step-by-Step Confirmation then the computer gives you i list of driver it runs.
Thanks
Evan